P345D BMW Fault Code

Description:

Fuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value.

Low fuel pressure Damaged BMW FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.

P345D Code Symptoms :

If your vehicle failed a P345D test and the P345D Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P345D a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look : Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.

Diagnosis And Repairing P345D

P345D OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P345D code ?

• 1Camshaft Position Sensor circuit poor electrical connection
• Faulty Variable Camshaft Timing (VCT) position solenoid
• Incorrect fuel pressure
• Insufficient cylinders compression